Cabletron Systems RoamAbout Guia de Instalação descarregar pdf (Página 24)

Rack Mount Kit Installation

2-6 Cabling and Wiring

Rack Mount Kit Installation Procedure

Use the following procedure to install the rack mount kit.

Step Action

1 If available, use a cable tester to check the cable wiring to each Access

Point.

Check continuity and pairing.

2 Select a mounting location:

• Close to the Ethernet wiring panel.

• Within six feet of an AC power outlet (if remote power is used).

3 Install up to three remote power adapters within the rack mount panel.

Use the screws provided in the rack mount kit to secure each remote power

adapter to the rack mount panel.

4 Secure the rack mount panel to the rack using the screws provided in the kit.

5 Insert an Ethernet cable connector into the NETWORK jack of one of the

remote power adapters.

6 Insert an Access Point cable connector into the ACCESS POINT jack of the

same remote power adapter.

Before you connect to the remote power adapter, verify that the wired

network connector is inserted into the NETWORK jack, and the

Access Point is connector is inserted into the ACCESS POINT jack.

7 Repeat Steps 5 and 6 for each Access Point.

8 Proceed to Chapter 3, Installing the Access Point.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Sem comentários

Cabletron Systems RoamAbout Guia de Instalação Página 24