Cabletron Systems RoamAbout Guia de Instalação descarregar pdf (Página 26)

Selecting the Correct Ethernet Wiring Configuration

2-8 Cabling and Wiring

Installing the 120 VAC Power Module

The only installation required for the 120 VAC Power Module is to plug it into an

appropriate wall outlet or extension cord.

Selecting the Correct Ethernet Wiring Configuration

If you have an existing 10BaseT Ethernet cable in place, you can connect the cable directly

to the Access Point. You can also connect the Ethernet cable to the remote power adapter,

then connect the remote power adapter to the Access Point.

If you plan to connect the Ethernet cable to the Access Point using a MOD-TAP connector,

refer to the following sections for information on the CAT 5 cabling standards and wiring

the MOD-TAP connector.

To ensure correct system operation, make sure you select the appropriate straight-through

or crossover Ethernet wiring configuration for your installation.

Do not connect the power module to the primary power source until

instructed to do so.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

Sem comentários

Cabletron Systems RoamAbout Guia de Instalação Página 26