Cabletron Systems RoamAbout Guia de Instalação descarregar pdf (Página 63)

Installing the Access Point 3-27

Verifying the Operation of the Access Point

The Access Point runs a series of self-tests on power-up and reports status using its LEDs

(Figure 3-1). The diagnostics take several seconds to complete after power-up. Table 3-1

describes the LEDs. If the Access Point LEDs indicate an error, verify that you have

correctly installed the Access Point. Table 3-2 describes the patterns, the most likely

causes, and possible corrective actions. If the Access Point still fails, refer to the

RoamAbout 802.11 Wireless Networking Guide.

The Reload/Reset button shown in Figure 3-1 is used to download a new firmware image

to the Access Point, and to reset the Access Point to the factory defaults. The toggle switch

is reserved for future use. You need to write down the MAC address (in the MAC ADD

box) for use when configuring the Access Point.

Once the Access Point is installed and powered on, refer to the RoamAbout 802.11 Wireless

Networking Guide to set the Access Point parameters.

Figure 3-1: RoamAbout Access Point 2000 (Without Cover)

www.cabletron.com/wireless

MAC

ADD

TUV

S2S1

Toggle

Switch

Reload/Reset

Button

Status

LEDs

MAC

Address

1 2 ... 58 59 60 61 62 63 64 65 66 67 68

Sem comentários

Cabletron Systems RoamAbout Guia de Instalação Página 63