Cabletron Systems T2015 Guia de Instalação descarregar pdf (Página 170)

100

101

160 Installation Guide for Clients

Amplicard AC 210/AT

Required entry:

• drivername = ms2000$ or ms2000n$

This driver is for the following network adapters:

• Amplicard AC 210/AT

• National Semiconductor EtherNODE *16AT

• National Semiconductor AT/LANTIC EtherNODE 16-AT3

• Networth EtherneXt 16-bit UTP adapter

• Novell NE2000

• Novell NE/2

The following table summarizes the possible entries and values in the

[ne2000] section of the LAN Manager PROTOCOL.INI file:

Entry Units Range Default

drivername — — ms2000$ or

ms2000n$

interrupt integer 2–5 3

iobase hex. 200H–3E0H 300H

Entries in the [ne2000] section of the LAN Manager PROTOCOL.INI

file have the following meanings:

drivername

Identifies the driver name of the network device driver. The

drivername consists of the base portion of the filename, plus a digit

when more than one adapter is installed. The drivername is ms2000$

for the first adapter, ms20002$ for the second, and so on.

interrupt

Indicates the interrupt level of the network adapter.

iobase

Indicates the base I/O address for the network adapter. If this entry

does not match the adapter’s I/O address jumper settings, the driver

reports an error. Values range from 200H to 3E0H in increments of

10H. If multiple adapters are installed, the difference between values

must be at least 20H.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 418 419

Comentários a estes Manuais

Sem comentários

Cabletron Systems T2015 Guia de Instalação Página 170

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Cabletron Systems T2015