Cabletron Systems T2015 Guia de Instalação descarregar pdf (Página 57)

Chapter 4 Installing LAN Manager on OS/2 Workstations 47

After Installing an OS/2 Workstation

After installing an OS/2 workstation, you can do the following:

• Review the hardware settings for the network adapter. If these

settings are incorrect or incomplete, the system will not operate

correctly. If you use default settings, the system should operate

correctly. If you have modified the hardware settings, or if you have

software that does so, check and adjust the CONFIG.SYS,

LANMAN.INI, and PROTOCOL.INI files. For more information, see

Part 4, “Network Device Drivers.”

• Review or change the LAN Manager configuration you have just

defined and installed. For instructions, see Part 3, “Managing Your

LAN Manager Software Configuration.”

• After installing, review the STARTUP.CMD file on the computer.

STARTUP.CMD contains an exit line at the end; the Setup program

adds lines before the exit line. If an exit line appears in the middle (as

in a conditional IF/THEN structure within STARTUP.CMD), Setup

adds lines to the end, and you must manually remove the exit

command or move it to the end of the file. Otherwise, the lines added

by Setup will not run.

If STARTUP.CMD includes lines that call other batch files, be sure

that the lines added by Setup will run. Move the lines, or be sure that

each call is made with the call command, so that control returns to

STARTUP.CMD after running each batch file.

• Be aware of a conflict between the RDRHELP.SYS and

COM0x.SYS device drivers. Setup inserts the following line into the

CONFIG.SYS file of an OS/2 computer:

The RDRHELP.SYS device driver ensures that the devicenames

COM1 through COM9 and LPT1 through LPT9 are recognized by

the operating system, so that LAN Manager can assign these

devicenames to network resources. RDRHELP.SYS detects COM

and LPT devicenames installed by the operating system, and it then

creates “dummy devicenames” for any that are not already installed.

If the CONFIG.SYS file contains the line device=c:\os2\com01.sys

or any other line that installs a COM or LPT device, these lines must

appear before the line device=c:\lanman\netprog\rdrhelp.sys. Setup

checks for device=c:\os2\com0x.sys lines, so you need to check only

if you edit the CONFIG.SYS file or if you add a COM or LPT device

driver after you install LAN Manager.

If you manually alter CONFIG.SYS, be sure that the LAN Manager

configuration information added by Setup appears at the end of the

file.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 418 419

Sem comentários

Cabletron Systems T2015 Guia de Instalação Página 57