Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 39)

Installing Your Access Point 3-9

Installing the AP into a MultiSwitch 900 or DEChub 90

Seating the Module in the MultiSwitch 900 or DEChub 90

The hot-swap feature allows you to install the module in the MultiSwitch 900 or

DEChub 90 without turning off power. Seating the module initiates the power-up

sequence.

NOTE

Do not try to insert a PC Card into the AP while the AP is powered on. Refer to

Chapter 2 for instructions on how to insert the PC Card.

Always remove the AP from the MultiSwitch 900 or DEChub 90 before swapping

a PC Card.

Perform the following steps to install the AP in the MultiSwitch 900 or DEChub 90:

NOTE

When installing the AP into a DEChub 90, you must connect the setup port device

to the setup port before applying power to the AP.

Step Action

1 Place the module’s mounting tab into the first mounting slot on the

MultiSwitch 900 or DEChub 90, as shown in Figure 3-7.

2 Pivot the module on the mounting tab and align the connectors.

3 Firmly push the module onto the backplane connectors until the release

lever clicks.

4 Press down on the release lever to ensure that it is locked.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 39