Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 51)

Configuring Your Access Point 4-7

Configuring the Access Point Using the Setup Port

The setup port (on the MultiSwitch 900, or as a standalone) allows you to access and

set Access Point parameters. This section describes how to access the module from

either port and how to set those parameters.

Examples of the actual setup screen displays are provided in this section to aid in the

description of the setup port and to display the options that are available. Because they

are examples only, the displays can vary slightly from the actual screen displays on

your setup port device. Boldface type in the screen display examples indicate user

input.

The format of an IP address is the standard 4-octet dotted decimal notation, where each

octet of the address is represented as a decimal value, separated by a decimal point (.).

The following is an example of an IP address: 16.20.54.156

Setup Port Signaling Standards

Signals from the MultiSwitch 900 setup port and from the standalone setup port

conform to the EIA-232D signaling standard at 9600 baud only. To the user, the port

appears as a data terminal equipment (DTE) device.

Connecting to the Setup Port

The setup port on the AP standalone unit or the MultiSwitch 900 can be connected to

a setup port device (a terminal or personal computer) by using the cables and adapters

listed in Table 4-1 and shown in Figure 4-1. Refer to Appendix A for the setup port

connector, cable and adapter pinouts.

To connect to the Access Point setup port, do the following:

Step Action

1 Ensure that the transmit and receive baud rates on the setup port device

are set to 9600 baud only.

2 Connect the setup port device to the setup port connector on either the

Access Point front-panel serial port or the MultiSwitch 900 setup port.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 51