Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 47)

Configuring Your Access Point 4-3

Configuring the AP Using the RoamAbout Access Point Manager

Installation and Setup

To install the Roamabout Access Point Manager, install the floppy disk (disk 1 of 2)

in the PC and run A:SETUP (this can be done from the Windows Explorer, DOS

prompt or via the Start Bar Run option). This software can only be run on Windows

95, Windows 98 and Windows NT V4.0. This software can also be run on either a

wired PC or a wireless PC. NOTE: If running it on a wireless PC, you can not upgrade

the firmware on the RoamAbout Access Point that you are connected to.

The Setup utility will add a program group to the Start Bar / Programs area with the

name RoamAbout. Under RoamAbout you will have a new program called

“RoamAbout Access Point Manager”. When you select this, the program will start

with the following screen.

You can add new APs by selecting the ‘Setup/Add New Access Point’ button. At this

point you will be prompted to add a new AP with or without a set IP address. If the AP

already has an IP address set, select NO, but if you need to set an IP address on the AP

select YES and fill in the required information.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 47