Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 42)

Verifying the Operation of Your Access Point

3-12 Installing Your Access Point

Verifying the Operation of Your Access Point

The Access Point runs a series of self-tests on power-up and reports status using its

LEDs.

When power-up begins, the following occurs:

The diagnostics take approximately 10 seconds to complete after power-up. Upon

successful completion of the diagnostics, the LED pattern shown in Figure 3-9 is

displayed.

If the unit fails to display the proper LED pattern, verify that you have correctly

installed the module according to the instructions in this chapter. If the unit still fails

to display the LED pattern shown in Figure 3-9, refer to Chapter 5.

Stage Description

1 The firmware begins running diagnostics, initializes minimal hardware,

then sequentially turns LEDs 2 through 6 on and off.

2 After LED 6 turns on and then turns off, the firmware completes its

diagnostics and hardware initialization. During this portion of the

diagnostics and hardware initialization, LEDs 2 through 7 flash on and

then off.

3 The diagnostics then checks to see if a PC Card is properly inserted in

the AP. If a card is present, LED 7 lights.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 42