Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 69)

Configuring Your Access Point 4-25

Access Point Installation Menu

[9] Module-Specific Options

[5] Set Bridge Mode

Option 5 allows you to specify the bridge operating mode of the AP.

The default operating mode of the AP is Workgroup Bridge mode. If you change the

bridge mode, you must select Option 2, Reset with Current Settings, from

the Access Point installation menu to reset the AP with the new mode.

When the AP is operated in Workgroup Bridge mode, it learns only the addresses on

the wireless side of the Ethernet LAN.

When the AP is operated in Full Bridge mode, it learns the addresses on both the

wireless and wired sides of the Ethernet LAN.

NOTE

Refer to Access Point Bridging Services on page 1-10 for a detailed description

of Workgroup Bridge mode and Full Bridge mode.

The following example shows the dialog associated with this option.

=======================================================

Bridge Mode Options

[1] Workgroup Bridge Mode

[2] Full Bridge Mode

*** NOTE ***

You must Reset the System with Current Settings for

the new configuration parameters to take effect.

========================================================

Enter selection [1] :

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 69