Cabletron Systems RoamAbout Guia do Utilizador descarregar pdf (Página 48)

Configuring the AP Using the RoamAbout Access Point Manager

4-4 Configuring Your Access Point

When you first establish communications with the AP, you will be prompted for some

general information and then prompted for your wireless parameters. It is highly

recommended that you change the ‘Wireless Network Name’ from the default. ALL

APs and clients on the LAN must share the same ‘Wireless Network Name’.

The figures below show the Wireless Network Name and the Station Name being

changed. These changes will take effect after the next AP reset. To reset the AP, select

‘Reset/Reload’ from the AP Manager and then select ‘Reset with Current Settings’.

You can continue at add all your APs within a wireless domain (defined by the same

Wireless Network Name) so that they all show up in one Managed List for future

changes. Before you EXIT, make sure to save your configuration (you will be

prompted). If you are managing APs in multiple domains (different Wireless Network

Names) you should save these APs in a separate file name.

Other management functions you can perform from this utility include: basic protocol

filters, looking at AP statistics, looking at AP hardware (version numbers, MAC

addresses, amount of memory, and card type), troubleshooting (last 4 error messages),

and resetting the AP.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 89 90

Sem comentários

Cabletron Systems RoamAbout Guia do Utilizador Página 48